Question 1
A 120-volt load draws 10 amperes. Approximately how much power does the load consume?
Show answer & explanation
Correct answer: C - 1,200 watts
10 exam-style questions with answers and explanations, straight from our 1,030-question bank. Tap an answer to check yourself. When you're ready, take the scored version in the free practice test.
The KY-JE exam has 80 questions and runs 3 hours.
These 10 free KY-JE questions are organized by exam domain, so you can see how each part of the Kentucky Journeyman Electrician License Exam blueprint is tested. Reveal the answer and explanation under each question.
A 120-volt load draws 10 amperes. Approximately how much power does the load consume?
Correct answer: C - 1,200 watts
An electrical plan shows a panel location but the connected load information is missing. What should the electrician do before installation?
Correct answer: B - Confirm the missing load information
A dwelling branch circuit supplies a continuous load of 16 amperes. What is the minimum calculated load used for sizing the circuit?
Correct answer: B - 18 amperes
A metal junction box contains splices but is not connected to the equipment grounding conductor. What correction is required?
Correct answer: A - Bond the metal box to the grounding system
Conductors are installed in an environment with a higher ambient temperature than standard tables assume. What must be considered before final conductor selection?
Correct answer: A - Ambient temperature correction factors
A motor starter trips shortly after startup. Voltage and phase match the nameplate. Which item should be evaluated first?
Correct answer: A - Motor protection and overload settings
A receptacle is installed where personnel may encounter water near a sink. Which protection is commonly required?
Correct answer: A - Ground-fault circuit-interrupter protection
Electrical equipment is installed in a wet location. Which requirement is most important?
Correct answer: A - Use wiring methods listed for wet locations
What is the primary purpose of an automatic transfer switch in a standby power system?
Correct answer: A - Transfer selected loads between power sources
When installing communication cable near power conductors, what factor is most important?
Correct answer: B - Required separation and installation rules
The KY-JE exam also covers these domains. Drill them in the full free practice test:
The full bank has 1,020 more KY-JE questions with explanations.
Continue in the free practice test →
View plans